Tools needed for installation:

Phillips screw driver, power drill, ¼ in. & 1/8 in. drill bits, 5/16 masonry drill bit, and silicone.

*For models C400 & C500 you may need misc. conduit, fittings, and accessories.

Is professional installation necessary?

It’s recommended, but if you’re experienced with a power drill and some basic tools, you can easily do it yourself.


Before Starting installation:

Make sure you visually inspect where this product is going to be installed. Next, inspect that the phone box or phone system is NOT BLOCKED by any electrical conduit or gas meters etc., that would interfere with the installation of this product.

If there is a problem, contact an electrician or the gas company for any modifications or re-locations.

Also check to see if the surface you are mounting it on is relatively flat. If there are any flaws in the surface, sand or modify the surface so that the product fits well.

If there is a circuit breaker box or other object mounted next to phone box etc., there must be at least 1.25 in. gap between the two.
See example A below

APPLICATIONS


MODELS C100, C200, C300

Designed for phone boxes built into the exterior wall of the home. (Telephone lines are generally underground) May need more than 1 enclosure if another service box is directly below or above Phone box.
See example B below

MODELS C400, C500

Designed for telephone networks or protectors that are exposed. (Telephone lines are generally above ground exposed)
See example C below

Application below has Exposed Telephone Network Interface, this example required COMOK Model C500.

As you will see there are dozens of other applications for these enclosures in the security industry.